buy semi-finished 1-test cyp 200mg/ml injectable oils

buy semi-finished 1-test cyp 200mg/ml injectable oils

1-testosterone (dihydroboldenone), or DHB for short, is an anabolic steroid that has some unique properties of interest to bodybuilders. Interestingly, in spite of the fact that the name can be confusing, in no way is DHB testosterone. In fact, it is simply the 5alpha reduced form of Equipoise (boldenone), which acts in a completely different way. Therefore, you can think of it as a dihydrotestosterone (DHT) version of equipoise.

Typical cycle
Users will usually kickstart their cycle off with an oral and then stack around 400-500 milligrams (mg) per week of DHB with some long estered testosterone. When you do this, you should also run an aromatase inhibitor (AI) to offset the estrogen increases from testosterone, and you should also use such support supplements as N2Guard.

Female use:
Virilization symptoms such as deepening voice, enlarged clitoris, and facial/body hair can occur when females intentionally, or accidentally, run androgenic compounds. As stated above, although DHB on paper is as androgenic as testosterone, that doesn’t mean that it will yield as much androgenic symptoms as testosterone, so females usually chose DHB over testosterone. What’s more, DHB is structurally more similar to primobolan and equipoise than to testosterone, so the virilization risk is lower.
In the end I would only recommend DHB to very experienced females who are aware of the risks, as DHB is in no way a weak steroid. Female users should start low at 25 milligrams (mg) per week, and work their way up to 75mg per week at the most.


Half life:
DHB is usually tied to the cypionate ester, hence the half life in that case would be of approximately 8-10 days. It is wise to inject every 4-6 days, and once you stop using DHB, it will take about 4-5 weeks to completely clear your system.
However, DHB is also found in propionate and other ester forms as well. Therefore, the frequency of the necessary injections and the clearance time will greatly depend on the ester you use.

could 1-testosterone cypionate be made into injetables?if yes,how do make it?
yes,u could check this for references,the details are as follows,
Receipes for 1-test cyp:
1-test cyp 200mg/ml: 1000ml:
2% BA 20ml
10% BB 100ml
10% Guiacol 100ml
75% of total oil used GSO 585ml
25% of total oil used Eathyl Oleate 195ml


Step 1:
mixed 1-test cyp powder 200g,2% BA 100ml, 10% Guiacol 100ml,75% GSO 585ml,25% ethyl oleate 195ml together,then use alcohol burner or heating element to heat this mixed substances into purity oils.meanwhile,when u are heating the mixed substance, u need to use glass rod to stir the mixed subtances,to make the oils be heated on average.

Step 2:
after u heat the mixed substances into purity oils,u need to wait for 2 to 3 minutes, to make the purity oils cool down for a while,The purpose of this is that when you filter the oil,The purpose of this is that when you filter the oil, it will not burn youself, and also ensure that the filter machine won’t be damaged.

remark:when u test the oils temperature is for 60℃ to 70 ℃,u could take the 1-test cyp 1000ml oils to have a filter,meanwhile,u also need to prepare the filter paper,to make the semi-finished oils be filterted in sterile.

filter times:3 times
filter paper size:Ф50mm*0.45um Nylon material